Back

Suggested Uses

As a high performance topcoat over properly prepared primed or sealed substrates and sanded stable coatings, including: Hot and Cold roll steel, Galvanized Steel, Aluminum, fiberglass, plastics and wood where:

• Outstanding Gloss and color retention are desired.

• Outstanding adhesion and flexibility is required.

• Excellent durability and chemical resistance.

• Car finish appearance.

• Excellent DOI and leveling is required.

• Excellent performance when using air-assist airless, pressure pot, cup gun and Roller or brush application.

​

Components

• 6H.1. K1 Base

• 0G.013 Medium Polyurethane Reducer

• 0G.030 Slow Polyurethane Reducer

• 0A.014 Hardener

​

Mixing Ratio
Mix:             Mix two (2) parts base color to one (1) part 0A.014 hardener.
                   Reduce with Selected Reducer 15-20%

 

Application
Apply:         Two medium wet coats, allow 10-20 minutes flash between coats.

​

Spray Gun:   HVLP Gravity Feed – 1.4 – 1.6mm tip and needle
                     Pressure Pot HVLP – 1.0 – 1.1mm tip and needle
                     Air Assist Airless - 1.0 – 1.1mm tip and needle
                     Conventional – 1.4 – 1.7mm tip and needle

 

Film Build:    40-50 microns – when applied as directed.