Back

Suggested Uses

As a high performance topcoat over suitable primers or over properly prepared substrates, including: Hot and Cold roll steel, Galvanized Steel, Aluminum, fiberglass, plastics and wood where:

• Outstanding Gloss and color retention are desired.

• Outstanding adhesion and flexibility is required.

• Excellent DOI and leveling is required.

• Excellent performance when using air-assist airless, pressure pot, cup gun.

• Can be applied in small areas with roller or brush.

​

Components

• 6B.1. K1 Base

• 0G.013 Polyurethane Reducer Standard

• 0G.030 Polyurethane Reducer Slow

• 0A.014 Hardener

​

Mixing Ratio
Mix:  Mix four (4) parts base color to one (1) part OA.014 hardener.
        Reduce up to 5 - 10% with Selected Reducer.

 

Application
Apply:         One or two crossed coats

​

Spray Gun:   HVLP Gravity Feed – 1.4 – 1.6mm tip and needle
                      Pressure Pot HVLP – 1.0 – 1.1mm tip and needle
                      Air Assist Airless - 1.0 – 1.1mm tip and needle
                      Conventional – 1.4 – 1.7mm tip and needle
                      Airless Not recommended.

 

Film Build:    60-90 microns – (2.4 – 3.6 mils.) when applied.