Suggested Uses
As a high performance topcoat over properly prepared primed or sealed substrates and sanded stable coatings, including: Hot and Cold roll steel, Galvanized Steel, Aluminum, fiberglass, plastics and wood where:
-
Outstanding Gloss and color retention are desired.
-
Outstanding adhesion and flexibility is required.
-
Excellent durability and chemical resistance.
-
Car finish appearance.
-
Excellent DOI and leveling is required.
-
Excellent performance when using air-assist airless, pressure pot, cup gun and Roller or brush application.
Components
-
5J.1. K1 Base
-
0G.060 5J Series Reducer (Preferred option)
-
0G.013 Standard Urethane Reducer
-
0G.030 Slow Urethane Reducer
-
0A.H10 Hardener
Mixing Ratio
Mix: Mix three (3) parts base color to one (1) part 0A.H10 hardener.
Reduce 5%-25% with Selected Reducer.
Application
Apply: Two medium wet coats, allow 10-20 minutes flash between coats.
Spray Gun: HVLP Gravity Feed – 1.4 – 1.6mm tip and needle
Pressure Pot HVLP – 1.0 – 1.1mm tip and needle
Air Assist Airless - 1.0 – 1.1mm tip and needle
Conventional – 1.4 – 1.7mm tip and needle
Airless Not recommended.
Film Build: 60 - 70 microns – (2.5 – 3.0 mils.) when applied as directed.